Finish, assemble and glue your beautiful work pieces this week. The Special Clamping Solution Kit is on special this Wood Working Wednesday at Tools4Wood. Special valid for today only, don’t lose out!
The WoodRiver clamping system applies equal pressure from all four directions (top, bottom, and both sides). Ideal for gluing table tops, shelving, veneer, and laminates. Attach clamps to any length 2 x 2’s (a 2 x 4 ripped in half) with screws provided, set jig and turn handle to tighten (on large pieces, position every 12″-18″ for maximum clamping efficiency). Clamp has plastic pressure pads and two 19-1/2″ tail bars of tough plastic with 12 notches to handle a variety of stock widths. It can be used on boards up to 6″ thick. Includes two clamps, two short bars, two long bars and screws. Comes with complete instructions, 2 x 4’s not included. Replacement “long” and “short” notched plastic clamping bars are available separately.
- Applies equal pressure on all four directions
- Includes 2 clamps, 2 short bars, 2 long bars, screws
- 2 x 4’s not included
Woodpeckers® clamping accessory; the BC4-M2 Box Clamp is a simple device that eliminates the hassle of using heavy, expensive bar clamps for assembling boxes, drawers and especially full size cabinets. With the BC4-M2 Box Clamp, you can dry-fit and square up all your parts at the same time without any bulky clamps and before having to use any glue, screws or nails. You’ll know right from the start if what you are building will assemble to the final dimensions, be as square as you need or if minor trim cuts are necessary. You can do all of that without a second set of hands to hold pieces in place while getting a bar clamp in position and tightened up. And once your project is held together with the Box Clamps, you can immediately install any type of screws (even pocket screws) or nails because all of the corner joints are left fully accessible. There’s nothing to get in your way. No more struggling to get corners even with the uneven clamping typical of a bar clamp.The Box Clamps are designed for any 90° joint, including butt joints, lap joints, T-joints, miter joints, box joints, dovetails and more, even if material is extending past the face. Molded from a special combination of glass reinforced polycarbonate, the BC4-M2 Box Clamp is virtually indestructible and comes with hardware for both hand as well as fixture use. The clamp will accommodate materials from 1/4″ to 1″ in thickness. Made in the USA.
- Includes 2 Blocks and 2 Knobs to assemble one corner
- Glass reinforced polycarbonate; virtually indestructible
- Clamp any 90° corner
- Joints left accessible after clamping